Friday, November 1, 2013

More fine adjustments, modifications and renders

Another busy week has went by and we have put more new revisions into model.


Currently we are adding support for various types of heatsinks and tubing management. Due to size constraints we had to toss out the inner 140mm fans and only settle for 120mm ones. We also ended up raising the fans so they could be mounted inside motherboard compartment or outside motherboard compartment without bumping into anything.

At this time we have made the decision for low-profile heatinks work best (for aircooling). Heatsinks such as the NH-C14 fit just fine, but bigger ones such as Mega Shadow do not. The height is the limiting factor.  We added cutouts so Liquid CPU coolers (such as H50/80 etc..) can be easily installed without needing to disconnect tubes.


Support for standard PSU's and larger (longer) PSU's have also been added. The intake for PSU is now inside case, and exhaust is towards the back. This was done so the PSU was not recycling its own hot air.

2x90mm exhaust fans were also added to back to remove hot air from motherboard compartment.

That is all for now, we are still working on finalizing all the details for various components and expect to have another full post/renders soon!

No comments:

Post a Comment